- 01 Use only for quick fluid connection.
- 02 Always allow fluid to flow from the socket to the plug.
- 03Use sealing material on the pipe side.
- 04Do not exceed the maximum compression torsion, as tightening too tightly may damage the connector.
- 05Insert the hose all the way to the end of the pipe for connection, and tighten the hose band.
- 06When using the hose again, cut it over 4CM and use it (SH/PM)
- 07When the connector is used in a machine, vibration and shock are generated. Therefore, a rubber hose of at least 30 cm in length should be inserted between the machine and the connector.
- 08Install a stop valve in front of the socket on the air side.
- 09The compressed air in the plug will be released when disconnected. Hold the plug and remove.
- 10Do not use continuously beyond the maximum operating pressure.
- 11Use only in the operating temperature range. Otherwise, damage to the connection may occur.
- 12Use for air.
- 13Do not expose to shock or intentionally pull and bend.
- 14Use in a clean environment as sand or metal particles sticking to the sealed area may cause malfunction.
- 15Do not use as a rotating ring.
- 16If paint adheres to the connector, it may leak or stop working.
- 17Do not disassemble.
- 18Do not mix with other connectors other than DM Hi-Tech.
※ Be sure to keep the instruction manual during the use period.